Cascade E-Series - Solenoid Valve; Coil Service; Valve Service

To Next Page

To Previous Page

215204 Rev. 1 43

ERVICE

RC0204.ill

Coil

Solenoid Valve

Assembly

5.6 Solenoid Valve

5.6-1 Coil Service

1 Remove the cover from the valve assembly.

2 Disconnect the wires and diode from the coil terminals.

3 Loosen the end cover capscrews. Remove the end

cover and coil.

4 Install the new coil and end cover. Assure that the

terminals are positioned correctly.

5 For reassembly, reverse the above procedures except

as follows:

• Refer to the electrical schematic in Section 4.5 for

correct wire and diode installation.

5.6-2 Valve Service

• Check the plunger within the valve body for freedom of

movement. If jammed or damaged, replace the

solenoid valve as a complete assembly.