Cascade E-Series - Drum Arm Pad Surface Replacement

215204 Rev. 1 27
ERVICE
S
5.2-2 Drum Arm Contact Pad –
Surface Replacement
The following procedures can be performed with the
Clamp mounted on the truck.
Single Drum Arms.
1 Drill out the rivets using a 3/16-in (5 mm) drill bit. Drill
from the back side of the arm. Align the new contact
surface to the arm. Drill through using the 3/16 (5 mm)
drill bit. Rivet the contact surface to the arm.
Multiple Drum Arms
2 Remove the snap ring, pivot pin, thrust washers and
contact pads to provide access to the rivets. Replace
the contact surfaces as in Step 1. Reinstall the contact
pads.
CL0429.ill
CL0370.ill
1
2
Contact Surface
Rivet (6)
Pivoting
Contact
Pad