40 215204 Rev. 1
ERVICE
S
5.4-4 Cylinder Reassembly
(Continued)
8 Inspect the rod end anchor parts for wear and replace
if necessary. Reassemble the rod end, split rings and
anchor bar to the arm. Apply Loctite No. 242 (Blue) to
the capscrew threads and tighten to:
20, 30E, 33E – 30 ft.-lbs. (40 Nm).
40E, 45E – 50 ft.-lbs. (65 Nm).
9 Remove the hoses from the valve supply fittings.
Remove the drain hose and fitting from the valve TEST
port. Replace the TEST port plug.
10 Reconnect the supply hoses to the valve fittings.
11 Start the truck and operate the Clamp through ten (10)
complete cycles to remove trapped air from the
hydraulic system. Check for leaks. Check the Clamp
for proper operation (Refer to Section 2, Step 10).
CL0320.ill
8
9
11
To Next Page
Loading...