215204 Rev. 1 45
PECIFICATIONS
S
6.1-4 Torque Values
Fastener torque values for E-Series Clamps are shown in
the table below in both U.S. and Metric units. All torque
values are also called out in each specific service proce-
dure section throughout the Manual.
Ref. Fastener Size Ft.-lbs. Nm
1 Bearing retainer-to-bearing way (4) M-8 15 20 ■
2 End cap-to-cylinder (5 per cyl.) M-8 20 30
3 Piston retainer-to-cylinder (4 per cyl.) M-8 20 30
4 Anchor bar, cylinder rod-to-arm (8) M-10 30 40 ■
M-12 50 65 ■
5 Contact pad-to-stabilizer (12) M-12 50 65
6 Filler block-to-contact pad (12) M-10 18 25
7 Retainer-to-stabilizer (4) M-8 15 20
8 Spring-to-arm (4) M-10 30 40 ■
9 Quick-Change hook-to-baseplate (4) M-16 165 225
10 Bolt-on lower hook-to-baseplate (4) M-16 165 225
11 Cylinder/bearing way-to-baseplate (★) M-12 75 100 ▲
M-16 195 265 ▲
12 Upper hook-to-baseplate (4) M-20 235 320 ▲
13 Backrest-to-baseplate (8) M-12 75 100
14 Centering tab-to-baseplate (2) M-16 165 235 ▲
15 Valve-to-manifold (4) M-8 15 20
16 Manifold-to-cylinder (6) M-8 15 20
CL0297.ill
7
8
6
16
11
10
12
13
14
1
2
3
4
5
9
15
★ Number of fasteners varies depending on Model
■ Use Loctite 242 (Blue)
▲ Double-torque (tighten, loosen 1/2-turn, retighten)
To Next Page
Loading...