4 - INSTRUMENTS/CONTROLS
44
4. FEEDER CLUTCH SWITCH - To engage the feeder and header drive and automatic header
controls, the operator must be seated. Lift and push the feeder clutch switch forward to the ON
position to engage the feeder, header drives, automatic header controls and reel drive.
The feeder and header drives will not engage unless the SEPARATOR is also engaged.
If the FEEDER CLUTCH SWITCH is left “ON” and the operator is seated, engaging the
SEPARATOR will not engage the feeder and other functions as stated above. To engage the
feeder, the feeder clutch switch must be cycled.
NOTE: Automatic header controls include RTC (Return to Cut), Float (if equipped), Auto Header Height (if
equipped) and Field Tracker® Automatic Mode (if equipped).
NOTE: The operator’s seat on the Combine is equipped with a switch that permits operation of the feeder and
header drive only when the operator is seated. The feeder and header drive and the automatic header controls will
disengage seven (7) seconds after the operator leaves the seat and will remain disengaged until reset. To reset,
turn the FEEDER CLUTCH SWITCH off, then ON while the operator is seated.
5. MINIMUM REEL SPEED CONTROL - This
control is located under the right hand arm rest
and is used to set the minimum reel speed
when the REEL SPEED SELECTOR SWITCH
is in AUTOMATIC. Fully counterclockwise is
zero (0) reel speed.
RD97G033
5
To Next Page
Loading...
