Case IH AXIAL-FLOW 2588 - Control Lever

8 - LUBRICATION/FILTERS/FLUIDS
325
Combines with Power Guide Wheels
Block the drive tires to prevent machine movement.
Raise and block the power guide wheels so that the
wheels will rotate freely. Keep the hydraulic reservoir
fluid at the correct level. Oil must be visible in sight
gauge window. Stop the engine when adding
hydraulic fluid.
The bearings of each wheel motor are lubricated by
the hydraulic oil in the motor case so no maintenance
is required for either bearing.
* Check guide wheels for rotation and direction of rotation
** Combine will move if brakes do not hold.
*** Check guide wheels for correct direction of rotation.
Note 1 Continue if the guide wheels do not rotate or if the guide wheels rotate in the reverse direction.
Note 2 If the guide wheels rotate in the forward direction see your dealer for repair of the hydraulic system.
Note 3 If the guide wheels rotate in the reverse direction, continue the procedure. If the guide wheels rotate in the
forward direction see your dealer for repair of the hydraulic system.
COMBINE
SERVICE
BRAKE
ENGINE
RPM
TRANSMISSION
GEAR SHIFT
POSITION
PROPULSION
CONTROL LEVER
POSITION/ACTION
POWER GUIDE
WHEEL SWITCH
POSITION
LENGTH
OF TIME
RELEASED 1800 NEUTRAL NEUTRAL
POSITION
ON 3
MINUTES
RELEASED 2400 NEUTRAL MOVE LEVER 1/2
INCH FORWARD
OFF 2
MINUTES
RELEASED 2400 NEUTRAL MOVE CONTROL
LEVER 1/2 INCH
IN REVERSE
OFF 2
MINUTES
RELEASED
SEE NOTES
1 AND 2
2400 NEUTRAL MOVE CONTROL
LEVER 1/2 INCH
IN REVERSE
ON 30*
SECONDS
MAXIMUM
APPLIED**
SEE NOTES
2 AND 3
1100 3RD GEAR*** MOVE CONTROL
LEVER 1/2 INCH
IN REVERSE
ON 15*
SECONDS
MAXIMUM
APPLIED** 2400 3RD GEAR*** MOVE CONTROL
LEVER 1/2 INCH
IN FORWARD
ON 4
MINUTES
APPLIED** 2400 3RD GEAR*** MOVE CONTROL
LEVER 1/2 INCH
IN REVERSE
ON 4
MINUTES
APPLIED** 1800 3RD GEAR*** 1/4 INCH
IN FORWARD
ON 15
SECONDS
APPLIED** 1800 3RD GEAR*** 1/4 INCH
IN REVERSE
ON 15
SECONDS