4 - INSTRUMENTS/CONTROLS
36
6. AREA COUNTER SWITCH - If the AREA
COUNTER switch is pressed the area is shown
in the upper display with an “A” for acres or an
“hA” for hectares in the lower display. The Area
Counter will accumulate acres or hectares only
when the header width is more than zero (0); the
feeder is running; the Combine ground speed is
at least 0.8 mph (1.2 km/h) and the header is
below a user selected position.
Upon release of the AREA COUNTER switch the
display will continue to show the area for 4
seconds, then return to the previously indicated
information.
If the AREA COUNTER switch is pressed again
for at least 0.5 seconds during this 4 seconds the
display will shown tenths of an acre or hectare.
7. INCREASE VALUE SWITCH - This button is
used during Combine instrumentation calibration
to increase the numerical value or to cycle the
calibration options (See Combine
Instrumentation/Calibration/Diagnostics).
8. ALARM OFF SWITCH - This switch will
deactivate the shaft speed monitor audible
alarm.
9. DECREASE VALUE SWITCH - This switch is
used during Combine instrumentation calibration
to decrease the numerical value or to cycle the
calibration options (See Instrumentation/
Calibration/Diagnostics).
10. HEADER HEIGHT DISPLAY - The Header
Height Display consists of a height symbol and 2-
1/2 digits to show the height in inches or
centimeters for manual, return to cut and auto
height modes or pressure in percent for float
mode (See Header Controls in this manual).
11. TAILINGS MONITOR - Monitor is an eight
segment bar graph that illuminates from Left to
Right as volume of material in the tailings
auger increases.
548L94
6
7
RH97F037
8
9
10
11
To Next Page
Loading...
Need help?
General
