8 - LUBRICATION/FILTERS/FLUIDS
326
PTO HOUSING
PTO Oil Level
To check the PTO housing oil level, put the
Combine on level ground. Check the fluid level on
the PTO dipstick (1). If the fluid level is at or below
the ADD mark on the dipstick, add the
recommended fluid to the PTO to raise the fluid
level to the FULL mark. Add fluid through the fill
tube.
PTO Oil Drain
A drain valve (2) for the PTO oil is located on the
bottom of PTO assembly.
PTO Oil Change
To change the PTO fluid, put the Combine on level
ground. Place the end of the drain hose in a
container. Open the PTO fluid drain valve (2) and
drain the fluid from the PTO. For best results, drain
the fluid when the fluid is warm.
Close the drain valve and fill the PTO housing to the
FULL mark on the dipstick with the recommended
fluid.
RD01H114
1
RD01H243
2
RD01H243
2
To Next Page
Loading...
