8 - LUBRICATION/FILTERS/FLUIDS
327
FEEDER AND CLEANING FAN GEAR CASE
Check Oil Level
To check the feeder and cleaning fan gear case oil
level, the Combine must be on level ground. The
dipstick is located in the right front service door next
to the cab. If the oil level is at or below the ADD mark
on the dipstick, add the recommended oil to raise the
level to the FULL mark.
Oil Change
To change the oil, put the Combine on level ground.
Remove right hand separator side panel (1). Remove
drain plug (2) from canister bolt (3). For best results
drain the oil when the oil is warm. Install the drain
plug (2) into the canister bolt (3) and fill the gear case
through the dipstick tube.
RD00E001
A24379
RD00H009
1
2
3
To Next Page
Loading...
