4 - INSTRUMENTS/CONTROLS
66
COMBINE CALIBRATION
The following tables show the steps through the
calibration areas of the Combine instrumentation. In
each case use touch switches “A” to increase and “B”
to decrease the numerical values or to cycle the
options as needed.
The following touch switches are used in the
calibration of the Combine instrumentation:
“A”........................................... Increase Value Switch
“B”..........................................Decrease Value Switch
“C”.................................................. Hourmeter Switch
“D”..................................... Engine/Fan Speed Switch
“E”..................................Ground/Rotor Speed Switch
“F”....................................................Alarm Off Switch
497L94
A
B
C
D E
F
To Next Page
Loading...
