77
Template Name: OML_2_col Rac 0-00000
Template Date: 2001_03_06
5 - OPERATING INSTRUCTIONS
BEFORE STARTING THE ENGINE
Before starting the Combine for the first time and
before each operating period after that, make these
checks:
1. Make sure all persons that operate or do
maintenance understand that clean fuel is
important.
2. Check all lubrication points as shown in the
Lubrication Charts.
3. Check the oil level in the engine crankcase.
Check the fluid level in the hydraulic reservoir.
4. Check that the fuel tank is filled with clean fuel
that meets the specifications given in this
manual.
NOTE: Clean around the fuel tank cap before you
remove the cap.
5. Check the fuel system, cooling system and
engine oil pan for leaks.
6. Check the tension on all belts and chains.
7. Remove any water or sediment from the water
separator filter.
8. Check the air pressure of the tires.
9. Check the coolant level in the coolant reservoir.
Add water and Ethylene Glycol coolant as
needed.
10. Check to make sure the audible alarm and
indicator lamps operate correctly.
11. Check to see that all shields are correctly
installed and latched.
12. Remove all accumulated crop material from the
machine.
WARNING: Before starting engine study Operator’s Manual safety messages. Read all safety signs on
machine. Clear the area of other persons. Learn and practice safe use of controls before operating. It is your
responsibility to understand and follow manufacturers instructions on machine operation, service, and to
observe pertinent laws and regulations. Operator and Repair Manuals may be obtained from your
equipment dealer.
M103A
!
To Next Page
Loading...
Need help?
General
