7. Use (A) and (D) to move the pointer to
[MANUAL].
●
Selecting [OFFSET OFF] returns
barometric pressure calibration to its
factory default state.
8. Press (C).
This displays the manual correction
screen.
9. Use (A) and (D) to input the current
temperature.
10. Press (C) to complete the setting
operation.
After the setting operation is complete, a
check mark appears for a few seconds,
and then the barometric pressure/
temperature setting screen re-appears.
11. Press (E) to exit the setting screen.
Barometric Pressure and
Temperature Reading
Precautions
●
Barometric Pressure Reading
Precautions
●
The barometric pressure graph produced
by this watch can be used to obtain an idea
of upcoming weather conditions. However,
this watch should not be used in place of
precision instruments required for official
weather prediction and reporting.
●
Pressure sensor readings can be affected
by sudden changes in temperature.
Because of this, there may be some error in
the readings produced by the watch.
●
Temperature Reading Precautions
Body temperature, direct sunlight, and
humidity all have an effect on temperature
readings. To help ensure more accurate
temperature readings, remove the watch from
your wrist, wipe it dry of any moisture, and
place it in a well-ventilated location not
exposed to direct sunlight. You should be able
to take temperature readings after about 20 to
30 minutes.
Almanac (Sunrise
and Sunset Times,
and Moon Age)
You can check the sunrise/sunset times and
moon age for your manually specified Home
City or for location information obtained by
phone connection or GPS signal reception.
Watch Operation Guide 3515
50
To Next Page
Loading...
Need help?
General
