EasyManua.ls Logo

Casio 3564 - Time Correction; Using Watch Operations to Correct the Time Setting

Casio 3564
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Time Correction
Your watch can connect with a phone to obtain
information that it uses to correct its date and
time setting.
Important!
When you are on an aircraft or in any
other location where radio signals may
cause problems, enable the watch’s
Airplane Mode to disable connection
with your phone.
l
Using the Watch in a Medical
Facility or Aircraft
Referring to the information below, configure
the time setting in accordance with the method
that suits your own lifestyle.
Do you use a phone?
Time correction by connecting with your
phone is recommended.
l
Auto Time Correction
12:30
If your phone cannot connect with the
watch
You can correct time settings by
performing operations on the watch.
l
Using Watch Operations to Correct the
Time Setting
Using Watch Operations to
Correct the Time Setting
If your watch cannot connect with your phone
for some reason, you can use watch
operations to adjust date and time settings.
Setting the Time/Date
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
This causes the current step reminder
setting ([ON] or [OFF]) to flash on the
display.
3. Keep pressing (C) until the setting you
want to change is flashing.
Each press of (C) moves the flashing to
the next setting in the sequence shown
below.
Power Saving On/Off
Illumination duration
Operation tone enable/disable
Day
Month
Ye a r
Minutes
12/24-hour timekeeping
Hours
Seconds
Daily step target
Step Reminder On/Off
4. Configure the date and time settings.
To reset the seconds to 00: Press (D).
1 is added to the minutes when the
current count is between 30 and 59
seconds.
For all the other settings, use (D) and (E)
to change the flashing setting.
Holding down (D) or (E) scrolls through
settings at high speed.
5. Repeat steps 3 and 4 to select time and
date settings.
6. Press (A) to complete the setting
operation.
Note
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Watch Operation Guide 3564
16

Table of Contents

Related product manuals