Measuring a Split Time or Lap
Time
1. Enter the Stopwatch Mode.
l
Navigating Between Modes
2. Use the operations below to measure
elapsed time.
●
Each press of (A) displays the time
elapsed from the start of the stopwatch
operation up to that point (split time) and
the elapsed time for a specific segment
(lap time).
●
Split times and lap times are both
displayed at the same time. Lap and
split times up to the one hour are shown
in 1/100-second units. Subsequent
measurements after one hour are
shown in 1-second units.
[SPL]: Split time
[LAP]: Lap time
Minutes
Minutes
Seconds Minutes
Seconds
1/100 seconds
Hours
Seconds
Time Number* Time Number*
After first hour
First hour
* [F] is displayed for the final time
number when an elapsed time
measurement operation is stopped.
3. Press (E) to reset the measurement time
to all zeros.
Swapping the Display
Positions of the Split Time
and Lap Time
While the stopwatch is reset to all zeros, hold
down (E) for at least two seconds to swap the
lap and split time display locations.
Split timeLap time
Lap timeSplit time
Displaying the Current Time
During Stopwatch
Measurement
Press (A) to display the current timekeeping
time in the lower display. Press (A) again to
return to the normal stopwatch display.
Measurement
Measurement
Current time
Viewing Measured Time Data
Viewing Saved Data
You can use the operation below to view split
times and lap times.
1. Enter the Recall Mode.
l
Navigating Between Modes
●
This causes the latest measurement
number and date to appear.
Measurement number
Measurement date
Measured time
2. Press (A) to cycle through measurement
numbers.
●
Each time you press (A), the previous
measurement number appears.
Watch Operation Guide 3564
21
To Next Page
Loading...
