Alarm
The watch will beep when an alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
●
An alarm will not sound if the battery is low.
Using CASIO WATCHES to
Configure Alarm Settings
If the watch is paired with a phone, you can
also use the CASIO WATCHES phone app to
set alarms.
l
Configuring Watch Settings
Configuring Alarm Settings
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Press (D) to scroll through alarm numbers
([AL1] to [AL5]) until the alarm you want to
configure is displayed.
3. Hold down (A) for at least two seconds.
Release the button when the hours digits
start to flash.
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
4. Use (D) and (E) to set the hour setting.
●
Holding down (D) or (E) scrolls through
settings at high speed.
●
If you are using 12-hour timekeeping,
[P] indicates p.m.
5. Press (C).
This causes the minutes digits to flash.
6. Use (D) and (E) to set the minute setting.
7. Press (A) to exit the setting screen.
●
(alarm) is shown on the display
while an alarm is turned on.
Note
●
A beeper sounds for 10 seconds when
an alarm time is reached.
●
The watch will automatically return
from the Alarm Mode to the
Timekeeping Mode if you do not
perform any operation for about two or
three minutes.
●
Testing the alarm
In the Alarm Mode, hold down (D) to sound the
alarm.
●
To stop the alarm
Pressing any button while the beeper is
sounding stops it.
Watch Operation Guide 3564
18
To Next Page
Loading...
