EN-21
Playing on the Keyboard
You can change the ranges of the left and right keyboards in
octave units from their initial default settings. This comes in
handy, for example, if the initial default range is not enough
when one person is playing the left hand part and another
person is playing the right hand part.
1.
Press bp FUNCTION.
2.
Use the bo dial to display the “Duet” setting
name, and then press bp ENTER.
3.
Use the bo dial to display “U Oct.” (right-side
keyboard) or “L Oct.” (left-side keyboard) and
then press bp ENTER.
This displays the NUM indicator.
4.
Use the bo dial to change the setting.
• You can specify the right-side keyboard octave while
“U Oct.” is displayed, and the left-side keyboard octave
while “L Oct.” is displayed.
• Increasing the setting value by one raises by one
octave, while lowering the value by one lowers by one
octave. The initial default for both settings is 0.
5.
Press bp ENTER to apply the displayed
setting.
This causes the NUM indicator to disappear.
6.
Repeat steps 3 through 5 of this procedure as
required to specify settings for both
keyboards.
Example
Specifying 0 for “U Oct.” and 1 for “L Oct.” results in the
keyboard octaves shown below.
7.
To exit the setting screen, press bq TONE.
• The octave settings you configure with the procedure
above are retained even when you exit the Duet Mode.
Changing the Octaves of the Duet Keyboards
UOct
.
Left keyboard Right keyboard
1 octave higher than initial setting Unchanged
To Next Page
Loading...
Need help?
General
Weight and Dimensions
