E-51
Status of Indicator 1 on DT-X200:
Orange: Charging the battery pack.
Red Flashing: Standby due to battery pack error or the surrounding temperature is
out of the charging temperature range.
(charging begins when the temperature is within the charging
temperature range)
Green: Charging the battery pack is complete.
Status of Indicator 2 on DT-X200:
Blue Flashing: Operating via Bluetooth
®
.
Orange Flashing: Operating via WLAN.
Magenta Flashing: Ready to communicate (when a USB connection is selected).
Important!
Always make sure to fi rst remove the Handheld Terminal from the Ethernet
Cradle when switching the selector switch.
Allowing the power supply terminals become wet can cause an electric shock
or fi re. In addition, if the terminals become soiled, contact may be impaired
resulting in poor charging. For reasons of safety and maintaining charging
battery pack(s) in optimum condition, clean the power supply terminals by
wiping with a dry cloth or cotton swab after disconnecting the AC adaptor.
Never short out the power supply terminals of the Ethernet Cradle. This can
damage the Ethernet Cradle.
Note that subjecting the Cradle to impacts or strong vibration could dislodge the
Handheld Terminal. Also avoid any vibration or impacts during communication
with a LAN, USB client or USB host, as this can cause communication to be
interrupted.
When mounting the DT-X200, securely attach to the mount hooks of the
Ethernet Cradle and make sure that the power LED at the front of the Ethernet
Cradle is lit in green. Charging and communication will not proceed properly if
the DT-X200 is not mounted properly.
Always cap ports that are not being used. Using the Ethernet Cradle while the
ports are uncapped can cause damage.
If the hand strap is attached to the terminal, take care not to trap it when
mounting the DT-X200. Pull the hand strap out as shown in the illustration. If
you are having diffi culties mounting the DT-X200, attach the hand strap using
the strap hole on the top of the terminal.
Place the Cradle on a fl at, level surface and take care when placing the DT-X200
in or removing it from the cradle.
•
•
•
•
•
•
•
•
To Next Page
Loading...
Need help?
General