E-22
Attaching the Stylus Strap
Use the procedure below to attach the stylus strap.
Attaching the Hand Belt
How to attach the Hand Belt
1. First check that the hand belt hook is oriented so that
the projections are facing towards you, as shown in
the illustration. Then push the hook ends into the strap
holes in the terminal.
Check that the hook is securely attached.
2. Push the metal hand belt fi tting so that it engages with
the mount on the terminal, as shown in the illustration.
Check that the fi tting is securely attached.
3. Feed the end of the hand belt through the hand belt
hook, fold it back to a suitable length and then fasten
it using the hook and loop fastener.
To Next Page
Loading...
Need help?
General
