Casio DT-X400 Series - Calibrating Touch Panel Alignment

E-24
Calibrating Touch Panel Alignment
Whenever the response of the touch panel is poor, or operation being executed does not
match with the location you are tapping on the touch panel, please recalibrate the alignment
of the touch panel using the following method.
• Press the "Fn" key and then press the "4" key after confi rming that "Fn" is
displayed at the top of the screen.
The following screen is displayed.
* You can also display this screen by navigating as follows:
Application drawer → TouchCalibration
• Press the stylus against the center of the target mark (+ mark) as indicated on the
screen.
Press the stylus against the target mark on the screen 5 times to display the next screen.
Then hold down the center of the target twice.