44
Snapshot Tutorial
NOTE
• Lag Correction will not be performed if you press the shutter button all the way
without first pressing it half way.
• If the camera’s image size setting is 9M, 3:2, or 16:9 when you shoot with Lag
Correction, the size of the resulting image will be 6M.
• The shooting range of Lag Correction is narrower than that of the Single Shot
mode.
• The lag correction time you should select depends on a variety of factors. The lag
from the point when you decide to shoot to the point when the shutter actually
releases depend on the individual photographer and on shooting conditions.
Experiment with different settings until you find the one that suits you best.
• Failure to pay proper attention to the subject when shooting can increase the lag
time considerably.
• Note the following when selecting a lag correction time.
– If you are viewing the subject with the monitor screen, try selecting “
–0.2” as the
lag correction time. If you are looking directly as the subject, try “
–0.1”.
– If timing is off with the above settings, try changing the lag correction time to
“
–0.3” when using the monitor screen and “–0.2” when looking directly at the
subject.
• Using Lag Correction causes the flash setting to become ? (flash off)
automatically.
B
To Next Page
Loading...
Need help?
General
Weight and Dimensions
