38
GETTING READY
3. With the camera positioned so the monitor
screen is facing towards you as shown in the
illustration, place it onto the USB cradle.
The [CHARGE] lamp lights red and charging starts.
• It takes about 150 minutes to achieve a full charge. Actual
charging time depends on current battery capacity,
remaining power, and charging conditions.
When charging is complete
The [CHARGE] lamp, which was lit red during charging,
changes to green.
Remove the camera from the USB cradle and unplug the AC
power cord from the power outlet.
If the [CHARGE] lamp flashes green
This indicates that charging cannot be performed because you
have just finished using the camera, or because the temperature
in your location is too hot or too cold. If this happens, wait until
the camera returns to normal temperature. When the camera
returns to a temperature where charging can be performed, the
[CHARGE] lamp will light red.
Carefully insert the camera
as far as it will go.
Cradle contact
[CHARGE] lamp
Camera contact
To Next Page
Loading...
Need help?
General
