179
USING AUDIO
USING AUDIO
The dubbing feature of your camera lets you add audio to a
snapshot after you shoot it. A snapshot that includes audio
(regardless of whether the audio was recorded on the spot or
added later) is indicated by the “ ” icon.
You can re-record a snapshot’s audio whenever you want.
You can record up to about 30 seconds of audio for a snapshot.
• Audio is monaural.
1. In the PLAY mode, use [W] and [X] to scroll
through images and display the snapshot to
which you want to add audio.
2. Press [MENU].
3. On the “PLAY” tab, select “Dubbing” and then
press [X].
• This operation can be performed only while a snapshot is
on the monitor screen.
4. Press [SET] to start audio recording.
5. Press [SET] again to stop audio recording.
Recording will stop automatically after about 30 seconds if
you do not press [SET].
To play back snapshot audio
Perform the steps under “Listening to the Audio of an Audio
Snapshot” on page 147.
Adding Audio to a Snapshot
To Next Page
Loading...
