60
SHOOTING A SNAPSHOT
4. Shoot the image.
When the image is focused, press the shutter button the rest
of the way.
This will shoot the snapshot and save it to the memory card
or the camera’s built-in memory.
IMPORTANT!
• While the “Anti Shake” setting is “ Auto” or “
Camera Shake”, half pressing the shutter will cause the
camera to vibrate and emit an operation sound. This is
normal and does not indicate malfunction (page 124).
NOT
• The aperture value indicates the size of the opening that
lets light into the camera. A larger aperture value indicates
a smaller opening.
• Shutter speed indicates the amount of time that light is
allowed into the camera. A slower shutter speed means
that light is allowed in for a longer time. Shutter speed is
indicated on the monitor screen as seconds (1/1000
second, etc.)
If the image does not focus...
If the focus frame stays red and the operation lamp is flashing
green, it means that the image is not in focus (because the
subject is too close, etc.). Point the camera at the subject and try
to focus again.
Shutter Button
To Next Page
Loading...
Need help?
General
