145
EDITING IMAGES
1. Play back the movie you want to edit.
2. Press [SET] to pause
playback.
• Check to make sure that
“ ” (cut icon) is
displayed on the monitor
screen. If it isn’t, press
[SET] again.
3. Press [T].
• You could also perform the following steps in place of
steps 1 through 3 above.
1
In the PLAY mode, select the movie you want to edit
and then press [MENU].
2
On the “PLAY” tab, select “Movie Editing” and then
press [X].
4. Use [S] and [T] to select the cut operation
and then press [SET].
• To cancel movie editing, select “Cancel” and then press
[SET]. This will return to the paused movie playback
screen.
5. Select the frame
(point) where you
want to cut the movie.
• To cancel the cut operation, press [MENU]. This will
return to the screen in step 3.
Cut icon
To do this: Press this button:
Fast forward or fast reverse
playback
[X] or [W]
Pause or unpause movie playback [SET]
Scroll paused playback one frame
forward or back
[X] or [W]
Cut range (red)
To Next Page
Loading...
