165
OTHER SETTINGS
When changing the date and time setting, be sure to do so for
your Home City (the location where you normally use the
camera). If you already have your Home City setting configured
correctly, you can use the procedure under “Setting the Date
and Time for Your Home City” (page 166) to change the current
time setting only, if you want.
IMPORTANT!
• Changing the time and date setting without correctly
configuring your Home City setting first will cause all of the
World Time (page 168) dates and times to be off.
■ Selecting Your Home City
1. Press [MENU].
2. On the “Set Up” tab, select “World Time” and
then press [X].
This displays the current World Time settings.
To have the camera do this:
Select
this
setting:
Remember the numbers used for files. Files will
be named using the next sequential number,
even if files are deleted or if a blank memory card
is loaded.
• If a memory card is loaded that already has
files stored on it and the largest sequential
number in the existing file names is greater
than the largest sequential number
remembered by the camera, numbering of new
files will start from the largest sequential
number in the existing file names plus 1.
Continue
Restart the serial number from 0001 whenever all
files are deleted or when the memory card is
replaced with a blank one.
• If a memory card is loaded that already has
files stored on it, numbering of new files will
start from the largest sequential number in the
existing file names number plus 1.
Reset
Changing the Camera Date and Time
Setting
B
To Next Page
Loading...
Need help?
General
