64
Snapshot Tutorial
Use the procedure below to configure Handsfree Mode settings.
1. In the REC mode, press [MENU].
2. Press [4], use [8] and [2] to select the “
r
REC MENU” tab, and then
press [6].
3. Use [8] and [2] to select “Handsfree” and then press [SET].
4. Configure Handsfree settings.
Use the procedure below to reposition the motion detection area (Start self-timer
icon) as required when it (or the preview icon ) hinders your view of the display
image.
1. In the REC mode, press [MENU].
2. Press [4], use [8] and [2] to select the
“
r
REC MENU” tab, and then press [6].
3. Use [8] and [2] to select “Motion Position”
and then press [SET].
4. Press [RING].
• This will select one of the two icons on the
display. Pressing [RING] toggles the selection
between the start self-timer icon and the preview icon.
Configuring Handsfree Mode Settings (Handsfree)
Setting Description
Motion Shutter
Specifies the camera operation that enters the Handsfree
Mode.
Always:
The camera always remains in the Handsfree Mode,
regardless of whether or not the monitor screen is tilted.
180°only:
The camera enters the Handsfree Mode only when the
monitor screen is tilted upwards 180 degrees.
Off: Handsfree Mode disabled
Timer
Specifies the amount of time that should elapse until
shooting starts after the camera detects movement.
Settings: 0.5 sec, 1 sec, 2 sec, 10 sec
Repositioning the Motion Detection Area (Motion Position)
Start self-timer icon
Preview icon
To Next Page
Loading...
