Sampling Sounds and Playing Them on the Digital Keyboard
E-20
2.
Press
cr
and
cs
at the same time.
This enters sampling standby.
The allowable sampling time (in seconds) will appear on
the display momentarily and then the display will change
to the following.
3.
Output the sound in the direction of the
microphone.
Sampling will start automatically.
• Sampling will not start if the volume of the sound picked
up by the microphone is too low.
4.
After the sound you want to sample is finished,
press
cr
and
cs
at the same time.
Sampling will stop.
• Even if you do not press
cr
and
cs
, sampling will stop
automatically whenever there is no more sound being
input from the microphone. Sampling also will stop
automatically 10 seconds after it is started.
5.
Play something on the Digital Keyboard.
• You may not be able to get 10 seconds of sampling if
Digital Keyboard memory is low due to storage of other
data. If this happens, deleting other memory data you no
longer need will free up memory space and you should be
able to sample for 10 seconds. See “Deleting a Sampled
Sound” on page E-25 for more information.
• Sampling sound and storing it will delete any sound
data currently stored under the same tone number. To
help ensure that you do not accidentally delete
important data, be sure to read “Protecting Against
Accidental Deletion of Sampled Sounds” on page E-25.
■ How sampled sounds are played
Pressing Middle C (C4) will play back the original sound. The
keys to the left and right of C4 play the sound at different
pitches.
You can use the following procedure to loop a sampled sound
so it continues to repeat, as you play on the Digital Keyboard.
1.
Press
bo
(RHYTHM).
2.
Press
cr
and
ct
(FUNCTION) at the same time.
This enters repeat standby.
W
ai t in
g
Flashes
Sam
p
lin
g
Flashes
S1 :Or
g
nl
Sampled sound 1
Used memory
(Unit: Kbytes)
Remaining
memory capacity
Looping a Sampled Sound
C4
S
y
n t h P o
p
Lights
To Next Page
Loading...
Need help?
General
Weight and Dimensions
