EN-11
Digital Piano Operations
Layering makes it possible to sound with two different tones at
the same time. The tone that is layered onto another tone is
the “Upper2 part tone”, which in this manual is referred to as
the “Upper2 tone”. The tone upon which the Upper2 tone is
layered is the “Upper1 part tone”, which is referred to as the
“Upper1 tone”.
■ To layer two tones
1.
Use the procedure under “Selecting a Single
Tone” (page EN-10) to select the Upper1 tone.
2.
Select the Upper2 tone.
(1) While holding down 9 ELEC. PIANO, press a
keyboard key from A0 through C{2.
• For example, pressing the A}1 keyboard key will
select STRINGS 1 as the Upper2 tone and will
sound the confirmation tone using the STRINGS 1
tone.
• For information about the tone assigned to each
keyboard key, see “ELEC.PIANO Button +
Keyboard Key” in the separate “Keyboard
Function List”.
(2) Release 9 ELEC. PIANO.
3.
Enable layering.
(1) While holding down 9 ELEC. PIANO, press the
C7 keyboard key.
• Each press of C7 toggles layering between
enabled and disabled. A notification tone (page
EN-9) will sound to let you know whether layering
is enabled or disabled.
(2) Release 9 ELEC. PIANO.
• Now when you press a keyboard key to play, the
two tones (Upper1 and Upper2) you selected will
sound at the same time.
• To go back to playing with the Upper1 tone only,
disable the layer function.
• You can adjust the volume of the Upper2 part and configure
other Upper2 part settings. For more information, see
“Configuring Upper2 Part and Lower Part Settings” (page
EN-30).
• For information about adjusting the Upper1 part volume,
see “Adjusting the Upper1 Part Volume” (page EN-29).
■ To unlayer the keyboard
You can perform either of the operations below to unlayer the
keyboard.
• While holding down 9 ELEC. PIANO, press the C7
keyboard key.
Each press of C7 toggles layering between enabled and
disabled. After the notification tone sounds (page EN-9) to
confirm that layering is disabled, release 9 ELEC.
PIANO.
• Touch 8 GRAND PIANO or 9 ELEC. PIANO.
This unlayers the keyboard and selects the tone that
corresponds to the button you touched.
Layering Two Tones
To Next Page
Loading...
Need help?
General
