Digital Piano Operations
EN-20
The metronome sounds a regular tone to mark time. Use the
metronome when you want to practice playing at a regular
tempo.
■ To start or stop the metronome
1.
Touch 5 METRONOME.
This starts the metronome.
• LEDs above 6 a button flash yellow (first beat)
and red (remaining beats) in time with the metronome
beats.
• You can specify metronome tempo, beat, and volume
settings. Refer to the information below.
Specifying the Tempo (page EN-21)
To change the metronome beat (page EN-20)
To adjust the metronome volume (page EN-20)
2.
To turn off the metronome, touch the
5 METRONOME again.
■ To change the metronome beat
1.
While holding down 5 METRONOME, press a
keyboard key from C2 through A2.
• The beat setting changes in accordance with the
keyboard key you press, as shown in the table below.
2.
Release 5 METRONOME.
■ To adjust the metronome volume
1.
While holding down 5 METRONOME, press
the B}1 or B1 keyboard key.
• You can adjust the metronome volume within the
range of 0 (muted) and 42 (maximum). As you use the
B}1 and B1 keyboard keys to change the setting, the
reference tone (page EN-9) will sound any time the
value becomes a multiple of 10 (10, 20, etc.)
2.
Release 5 METRONOME.
Using the Metronome
Pressing
this key:
Selects this
setting:
Which does this:
C2 Off Sounds a click for all beats.
C{2 1 Sounds a bell for all beats.
D2 2
These keys specify a beat
setting of 2 to 9.
The first beat of each
measure is a bell sound,
while the remaining beats
are clicks.
E}23
E2 4
F2 5
F{26
G2 7
A}28
A2 9
Pressing this
key:
Does this:
B}1 Lowers the metronome volume one level.
B1 Raises the metronome volume one level.
B}1 + B1 Returns the metronome volume to its
initial default setting.
C1A0 C2 C3 C4 C5 C6 C7 C8
B1B}1
To Next Page
Loading...
Need help?
General
