EN-7
Overview and Setup
Your Digital Piano has three jacks for connection of pedals.
*1 Included pedal (SP-3) or separately available CASIO
sustain pedal.
*2 See “To specify the pedal type” (page EN-9).
• Pedals connected to the cr DAMPER PEDAL jack,
dl EXPRESSION/ASSIGNABLE jack, and cs PEDAL
UNIT jack can be used simultaneously.
• You can also use a pedal to switch the Digital Piano
registration setup. For details, see “Using a Pedal to Cycle
Through Multiple Setups (Sequential Pedal Recall)” (page
EN-42).
Connect the supplied pedal (SP-3) to the cr DAMPER
PEDAL jack.
Back
■ To change the function of the pedal connected to
the DAMPER PEDAL jack
You can use FUNCTION parameter 36 (“Pedal Target”) to
select one of the settings below.
• For information about FUNCTION parameters, see
“Configuring Function Settings (FUNCTION Mode)” (page
EN-53).
Using a Pedal
Jack Connectable Pedal
cr DAMPER
PEDAL
Switch type pedal*
1
cs PEDAL UNIT Separately available SP-34 pedal unit
(three pedals: damper, soft, and
sostenuto).
dl EXPRESSION/
ASSIGNABLE
Switch type pedal,*
1
expression
pedal*
2
DAMPER PEDAL Jack
cr DAMPER PEDAL jack (Standard jack (6.3mm))
SP-3
This setting
(displayed):
Does this:
Sustain Sustains notes played while the pedal is
depressed, even if the keyboard key is
subsequently released. Organ and
other tones that are sustained as long
as keyboard key are depressed
continue to sound as long as the pedal
is depressed.
Sostenuto Sustains only the notes of the keys that
are depressed when the pedal is
pressed until the pedal is released,
even if the keyboard keys are released
first.
Soft Slightly lowers and softens notes played
while the pedal is depressed.
Arpeggio Hold When the arpeggiator (page EN-27) is
enabled, applies arpeggio hold while
the pedal is depressed.
Play/Stop Performs the same operations as the
8a button.
Fill-in Plays a fill-in when the pedal is
depressed while an Auto
Accompaniment is playing.
To Next Page
Loading...
Need help?
General
