Message Format: BnH 10H vvH DSP Parameter7[0]
BnH 11H vvH DSP Parameter7[1]
BnH 12H vvH DSP Parameter7[2]
BnH 13H vvH DSP Parameter7[3]
BnH 50H vvH DSP Parameter7[4]
BnH 51H vvH DSP Parameter7[5]
BnH 52H vvH DSP Parameter7[6]
BnH 53H vvH DSP Parameter7[7]
n: MIDI Channel Number
vv: Value
Send This message is not sent by this Instrument.
Receive Receipt change the value of Parameter7 [0-7] (7-Bit Parameter) explained under20.3 Tone
Dsp Parameter . Any message received that corresponds to the parameter of a number not being used
by the currently selected DSP is ignored.
Received values and parameter setting values The range of the value of each DSP Parameter 7
array element depends on the selected DSP or array number. Unlike manipulation of a DSP parameter
using a System Exclusive Message, a value received by this control change message is always in the range
of 0 to 127, but the range is changed in accordance with the setting range of the applicable parameter
setting. Because of this, it is impossible for a value to be outside of the range. Conversion to the
parameter setting value from the value received with the message can be represented in general terms
by the expression shown below.
Parameter Setting Value = Parameter Minimum Value + (Parameter Maximum Value − Parameter Minimum Value) ∗
„
Received Value
127
«
For details about Parameter 7 of each DSP, see the explanations under VI DSP Parameter List .
8.9 Hold1 (40H)
Format
Message Format: BnH 40H vvH
n: MIDI Channel Number
vv: Value
Send Sent in the following cases.
• When a pedal that has a sustain (damper) function is operated
• When Accomp MIDI Out is on(PX-350M, AP-650M)
Receive Receipt performs an operation equivalent to a sustain (damper) pedal operation.
14