APPENDIX
169
Other
Symptom Possible Cause Action
Position the camera so sunlight does not shine
directly into the lens.
This camera cannot display non-DCF images
recorded onto a memory card using another digital
camera.
Remove the batteries from the camera, reinsert
them, and then try again.
1) After confirming that the computer is not
accessing camera memory, disconnect the USB
cable.
2) Press [DISP] to turn on the monitor screen.
1) Check all connections.
2) Install the USB driver on your computer (page
135).
3) Turn on the camera.
Color of the playback
image is different from the
image on the monitor
screen during recording.
Images are not displayed.
All buttons and switches
are disabled.
Monitor screen is off.
Cannot transfer files over a
USB connection.
Sunlight or light from another source is shining
directly into the lens during recording.
A memory card with non-DCF images recorded
with another camera is loaded in the camera.
Circuit problem caused by electrostatic charge,
impact, etc. while the camera was connected to
another device.
1) USB communication is in progress.
2) The monitor screen is turned off (in a recording
mode).
1) USB cable is not connected securely.
2) USB driver is not installed.
3) Camera is turned off.
Playback
To Next Page
Loading...
Need help?
General
