34
To change the power on password setting
1.
Perform steps 1 through 5 under “To change the password” (page 33) and
display the Password screen.
2.
After confirming that “Power On Password” is selected, use the [] and [] keys
to select either the “On” or “Off” setting.
Changing the setting from “Off” to “On” will cause the “Prompt for password when power is
turned on?” dialog box to appear. Press the [ENTER] key to confirm that you want to turn on
power on password protection, or [ESC] to exit the dialog box without changing the setting.
3.
After you are finished, press the [MENU] key to exit the setup menu.
To change the projector internal storage function password
(network models only)
1.
Perform steps 1 through 5 under “To change the password” (page 33) and
display the Password screen.
2.
Press the [] key to select “Internal Storage Password”.
3.
Use the [] and [] keys to select “On” or “Off”.
Changing the setting from “Off” to “On” will cause the “Prompt for password when an internal
storage operation is performed?” dialog box to appear. Press the [ENTER] key to confirm that
you want to turn on internal storage password protection, or [ESC] to exit the dialog box
without changing the setting.
4.
After you are finished, press the [MENU] key to exit the setup menu.
To Next Page
Loading...
Need help?
General
