moving money forward
Ensure the hopper and stacker are empty. Attach power cable to rear of the machine, plug into
a three-prong outlet and turn the power switch, located on the rear of the machine, to the ON position.
The unit will load and conduct a power on self-test (POST). The screen will display “0” when the unit
is ready to operate.
In order to avoid jams and ensure proper operating speed of the machine, it is important to correctly
load the hopper. Cassida recommends to not use more that 500 bills at a time and change to manual
mode until the technique of loading bills is mastered. Follow the 3-step loading technique below to
ensure smooth bill feeding.
1. Make A Stack
Correct or remove bills that are severely wirnkled, damaged or folded. Square the bill stack.
2.1 Powering Up
2.2 Loading the Hopper
GETTING STARTED
2.
10
To Next Page
Loading...
Need help?
General
