Cateye Padrone+ - Entering Tire Circumference

CATEYE PADRONE
+
Quick Start Manual
Setting up the computer
Setting the speed unit
Entering the tire circumference
Setting the clock display
Clear all data (initialization)
Measuring screen
(Setup completed)
Setting the hour
Setting the minute
Entering the tire circumference
Setting the speed unit
Clear all data (initialization)
MODE
MENU
MODE
Entering the tire circumference
Enter the tire circumference (mm) of your bicycle with 4
digits using the tire circumference reference table.
(0100-3999 mm)
Pressing the MODE button increases the value flashing,
and pressing and holding the MODE button moves to the
next digit.
After entering, press the MENU button to proceed to the
next step “Setting the clock display”.
Entering the tire
circumference
Move digit
Increase
the value
To the next step
(Press
and hold)
Tire circum-
ference refer-
ence table
Return
Return to Contents
Next