35
Regular Oil Change: After initial change, in normal conditions, the oil should be changed
every 2500 hours of operation or every 6 months.
To Refill: Determine position of reducer from the chart below and refill with amount of oil
shown in capacity chart.
Grease Fittings: The gear reducers have grease fittings to lubricate the input shaft bearing
if they are not positioned to be adequately lubricated by oil splash. Periodically lubricate
these bearings with a good grade of NLGI-No.2 Lithium Base EP Grease, applying only a
very small amount each time.
***************
To Next Page
Loading...
