FUNCTIONS
CAR BATTERY ALARM (B1)
Alarm goes off when the voltage goes above 12.5V.
LEISURE BATTERY ALARM (B2)
When leisure battery voltage reaches 11.5V the
leisure battery reserve alarm goes automatically on,
the symbol ref. 17 starts blinking, you hear a short
beep.
When car battery voltage goes below 12V Car
Battery Discharge alarm goes on and the symbol ref.
16 starts blinking.
,
When the leisure battery voltage reaches 10.5V, the
Leisure Battery Discharge alarm goes automatically
on, the symbol ref. 17 starts blinking, you hear two
short beeps.
Alarms go off when the voltage goes above 12.5V.
MINIMUM VOLTAGE CONTROL (BATTERY
PROTECTION)
The electronic battery protection device disconnects
the 12V users when leisure battery reaches 10V and
disables: pump, lights, , stove.awning light
Symbol ref. 15 is the visual alarm signal.
This device doesn’t control the the 12V users
connected directly to the leisure battery B2 .
Users are automatically reconnected with a voltage
higher than 13.5V.
It is possible to connect all users for one more minute
by pressing the on/off button (ref. on control panel).4
The control panel automatically turns off with a
voltage lower than 9.5V.
b) Waste water tank with screw probe.
A , (larm is acoustic (when engine is off) visual symbol
ref. 13 . blinking)
TANKS
graphically by the level guage ref. 11.
FRESH WATER TANK ALARM
a) Fresh water tank with electronic probe:
visualization in % (steps of 5%) and
A freshlarm turns on when water level goes below
1 % of the tank capacity and automatically turns off
when level exceeds 2 %.
5
5
- Both int. and ext. temperatures have a sensor,
- The precision of the temperature value is ±1°C.
at 5% and a long beep at 95%.8
getting filled: one short beep at 75%, two short beep
An electronic device switches off the awning light
which is placed inside or outside of the vehicle.
DIGITAL CLOCK
AWNING LIGHT AUTOMATIC TURN OFF
To set clock see “SETTING”.
T 1 2o exit this function press buttons ref. or .
“SETTING”. o reset alarm press any test button; T
TEMPERATURE
when engine is turned on.
ALARM CLOCK
To set and activate/deactivate the alarm clock see
there is no delayed alarm!
FRESH WATER TANK REFILLING
Alarm is shown acoustically (when engine is off) and
visually with the symbol ref. 14 blinking.
T freshhis function is used during the water
refilling and indicates the water level during refilling.
WASTE WATER TANK ALARM
To activate this function press the “test tank” button
ref.2 for more than 2 seconds, until the “water
refilling” is displayed on the screen.
The control panel beeps in order to warn that tank is
Alarm turns on when the waste water level exceeds
the screw sensor level.
19
EN
To Next Page
Loading...
