NOTICE TECHNIQUE V2 LIMPIDO-PRO
CCEI
page 4
-Phase 1, normal production. (40 minutes).
-Phase 2, rest (20 minutes).
-Phase 3, inverse mode production. (40 minutes).
-Phase 4, rest (20 minutes).
Two operating modes may be chosen depending on how much chlorine you want to
produce (p page 6), but in any case, your electrolysis unit should not be allowed to
operate unless the filtration is in service itself (see “flow detector” section), for safety
reasons.
Continuous mode (Manual operation):
In this mode, the LIMPIDO repeats its 2h00 production cycle throughout the entire
filtration period.
Programmed mode (Operation on the clock):
In this mode, the LIMPIDO only operates during the times programmed on its clock.
Its operating times within the periods determined for the filtration pump should be
defined (see example below).
Temps
t=0 t=40 t=60 t=100 t=120
Production
inverse
Production
Normale
Diagramme schématisant l’alternance des temps de production
et temps de repos durant un cycle complet.
va le urs ex
rimées en minutes
.
Normal
production
Inverse
production
Time
Diagram showing the alternation of production times
and rest times during one complete cycle.
(values expressed in minutes).
To Next Page
Loading...
