It is for switching the PBX ON / OFF.
Note: The PBX is supplied RJ Connectors with short leads for terminating the cables to RJ Sockets. It is recommended to
Crimp RJ connectors directly to the cables in order to maintain the aesthetics.
Precautions:
-
The Mains AC socket from where the PBX is given 220 V AC, should be separately made by taking direct connections
from the MCB Box and no other Electrical appliance should be connected on this point.
JUNCTION LINES - Telephone Lines provided by the Department of Telecom.
EXTENSION LINES - Extension Lines mean the EPABX extension lines.
To program most of the feature mentioned in this manual, programming Password is to be entered from programming
extensions (601 and 602) through the following command:
#0000 (Here, 0000 is the default Password)
In case of any mistake while programming, keep the Handset down and pick up again.
Whenever a correct input is entered, PBX will give one single acceptance tone and when wrong input is given, it will give
three tones.
Numbers to be allowed to extensions whose L = 0, are to be defined in this table. For value of L refer “Junction Dialing
Controls”.
This table has 16 Locations.
Procedure: Dial #0000 + 43 QQ ABCD#
Where QQ= 01 to 16 (16 Locations of the Table)
ABCD= The starting 4 digits of the Tel numbers to be allowed to extension.
For less than 4 digits, dial # at the end of digits.
To clear this Table, Dial #0000 + 43 #
To clear a particular location of this table, Dial #0000 + 43 QQ #
Note: This feature is optional, and can be provided at an extra cost.
When the PBX is operated in this mode, the Junction caller gets a welcome message.
Three types of messages can be recorded for the following 3 conditions:
Welcome Message (10 Secs)
Busy Message (5 Secs)
No Answer Message (5 Secs)
Auto Attendant Enable/ Disable:
To set Junction in Auto Attendant mode:
Dial #*0000 + 101 #
To set Junction in Direct Ring mode:
Dial #*0000 + 111 #
Message Recording/ Listening:
To Record Auto Attendant Message:
Dial #*0000 + 12 M #
Recording starts after a confirmation beep. There will be a second beep for recording end.
Listen Auto Attendant Message:
Dial #*0000 + 13M #
Where- M = 1 for Welcome Message (10 Secs)
= 2 for Busy Message (5 Secs)
= 3 for No Answer Message (5 Secs)
Busy Message ON/OFF:
The facility of playing Busy message can be turned ON or OFF.
To turn ON Busy Message: Dial #*0000 + 124 #
To turn OFF Busy Message: Dial #*0000 + 134#
Ring Time Setting:
This is the time for which call will ring on dialed extension.
Dial #*0000 + 496 TT # where TT is time duration in seconds (01-99)
To Next Page
Loading...
