Direct Ring Mode (Calls land on Operator or defined extensions in Simultaneous Ring mode or Round Robin
Ring mode)
Direct Ring Mode (Simultaneous / Round Robin)
Simultaneous Ring
In this mode, incoming Junction lines ring on one or more Extensions.
Incoming ring of Junction Lines can be programmed separately for Day and Night modes as described below:
Dial #0000 + 3 1 M 0 + N
1
+ N
2
…..+N
5
#
M = 0 for Day mode/ 1 for Night Mode
N
1
….N
5
= Here N is the last digit of Original extension number.
Round Robin Ring
In this mode, the incoming Junction call lands on one extension. If that extension is busy or doesn’t respond within few rings then the call
shifts to another extension.
Programming:
Dial #0000 + 3 1 M 1 + N
1
+ N
2
…..+N
5
#
M = 0 for Day mode/ 1 for Night Mode
N
1
….N
5
= Here N is the last digit of Original extension number. (Not the Flexible
Number)
When all assigned extensions are busy
When the extensions assigned for the Junction incoming call are busy, The assigned extension when busy, will hear a
waiting call beep after every 5 seconds. On flashing ext will get connected to incoming junction call.
Default: All the Junction Lines land on Extension number 601 and 602 in Simultaneous Mode.
To Enable Junction Line, Dial #0000 + 060 1 #
To Disable Junction Line, Dial #0000 + 061 1#
Note: In default Junction Line is enabled.
The PBX has memory for 48 telephone number that can be dialed from an extension by dialing 2 digits codes. However, if the ext is
given only local dialing facility, then it cannot dial STD number of the memory.
Storing Telephone number in memory- Dial #*0000 35 CC NN#
Where CC is Memory location (01-48)
NN is Telephone number maximum 16 digits
Note: In case mobile numbers are not dialing properly each time, add 0 or 00 before the
number while adding.
Deleting memory codes-
To delete a particular dialing code- Dial #*0000+ 35 CC#
To delete all memory dialing code- Dial #*0000+ 36#
Memory Dialing Enable/Disable-
To Enable Dial #*0000 + 37 0#
To Disable
Dial #*0000 + 37 1#
Default: Disabled
Note- If memory dialing is disabled then it will check the Junction dialing control for extension.
To dial a number from memory- Dial 7CC
In default Extension number 602 is defined as Operator and this extension can be changed if desired by the user.
To change the Operator Extension, Dial #0000 + 15N#
Where, NN = Last digit of Extension which is to be made the Operator.
Default: Operator Extension is 602
To call operator Dial 9
There is only one Password for the whole PBX programming and this Password can be changed by the user. The default
Password is 0000.
Process to change the Password: #0000 + 09xxxx# Here, 0000 = Default password
xxxx = New Password
To reset default Password: #*#*#*#
To Next Page
Loading...
