Junction lines can be accessed by dialing 0.
Every Extension can be programmed to access Junction Line.
The access to each Extension can be different in Day mode and Night mode.
Procedure:
Dial #0000 + 70 1 N X # (For Day Mode access)
Dial #0000 + 71 1 N X # (For Night Mode access)
N = Last Digit of Extension Number
X = 0 to allow Junction access
1 to Disallow Junction access.
Dial #0000 + 70 1 X # (To allow/disallow all extensions to access Junction in Day Mode)
Dial #0000 + 71 1 X # (To allow/disallow all extensions to access Junction in Night Mode)
Default: All extensions are allowed to access Junction Line in both Day and Night mode.
Junction dialing facility can be controlled Extension wise as below:
Dial #0000 + 40 N L #
where, N= Last digit of Extension number.
L = 0 - The Extension can dial only the numbers starting with digits defined in “Allowed Table”
1
- The Extension can dial all numbers.
2
- The Extension can dial all numbers except for ISD numbers.
3
- The Extension can dial all numbers except for STD numbers.
4
- The Extension can dial all numbers except for the numbers starting with digits defined in “Denied
Table-A”
5
- The Extension can dial all numbers except for the numbers starting with digits defined in “Denied
Table-B”
6
- The Extension cannot dial out but can make internal calls.
To give all extensions the same L value: Dial #0000 + 40 L #
Note: In default: all extensions are in L = 1 mode.
To transfer a Junction line to another extension, FLASH and dial the Extension number while talking on the junction line.
Now there can be following 4 conditions:
1.
When called extension lifts, calling extension can converse and then keep the Handset down. The Junction call will
then get transferred.
2.
Called extension lifts but doesn’t want to talk then he may keep the Handset down.
The call will come back to the transferring extension.
3.
The called extension is ringing but not lifting the Handset. Keep the Handset down.
The call will ring on the called extension for 25 secs and if not answered it will ring back on the transferring extension.
Now if the Transferring extension is busy, the Junction call will keep waiting for the Transferring extension to get free.
4.
If the called Extension is engaged, the user will hear 2 tones. Now FLASH to get back to the Junction line. If FLASH is
not done within 10 secs, the Junction line will get connected. This is the default setting in the PBX.
Alternately the user can change to the following mode:
On dialing an engaged extension user would get engaged tone. During the engaged tone user can FLASH and get
connected to the Junction line but call will not come back after 10 Secs.
Programming: Dial #0000 + 831 #
To shift back to the default setting, Dial #0000 + 830 #
This is the time after the last digit dialed by an extension on Junction Line.
It is 7 secs in default.
The PBX assumes call maturity from after the lapse of this time.
The FLASH function to hold an Incoming Junction call starts working after the lapse of this time.
To change this delay time, Dial #0000 + 03 TT # Where, TT= 01 to 99 secs. Default value = 07 (7 secs)
Junction lines incoming ring can be set in the Direct ring modes:
To Next Page
Loading...
