CCL 108SU - Conference with 1 Junction & 1 Ext; Day; Night Mode; Denied Table - a; Denied Table - B

6
. Day / Night Mode .
. Denied Table – A .
. Denied Table – B .
. Do Not Disturb (DND) .
. Door Phone .
. Emergency Call .
An extension user can establish a conference with an extension and a Junction line.
Process: During conversation with a Junction line, Hook-Flash to hold the line.
Then dial  Ext No.
The PBX can be configured in 2 sets of programming. One for the day mode and one for the night mode.
To change the system to Day Mode, Dial # 20
To change the system to Night Mode, Dial # 21
Default: Day Mode.
Numbers to be disallowed to extensions whose L = 4, are to be defined in this table. For value of L refer “Junction Dialing
Controls”.
This table has 16 Locations.
Procedure: Dial #0000 + 41 QQ ABCD#
Where QQ= 01 to 16 (16 Locations of the Table)
ABCD= The starting 4 digits of the Tel numbers to be denied to extension.
For less than 4 digits, dial # at the end of digits.
To clear this Table: Dial #0000 + 41 #
To clear a particular location of this table: Dial #0000 + 41 QQ #
Numbers to be disallowed to extensions whose L = 5, are to be defined in this table. For value of L refer “Junction Dialing
Controls”.
This table has 16 Locations.
Procedure: Dial #0000 + 42 QQ ABCD#
Where QQ= 01 to 16 (16 Locations of the Table)
ABCD= The starting 4 digits of the Tel numbers to be denied to extension.
For less than 4 digits, dial # at the end of digits.
To clear this Table: Dial #0000 + 42 #
To clear a particular location of this table: Dial #0000 + 42 QQ #
In DND mode, no one can call the DND extension
PROCEDURE: Dial # 83
To cancel DND, simply lift Handset.
Default: Normal Mode
One Door Phone can be connected to the PBX.
Open the back cover of the Door Phone and connect 2 wires on the Terminal block.
These 2 wires are to be connected to any of the Extension port (from 601 to 605) of the PBX.
To define the Extension as the first Door Phone extension, program as below:
Dial #0000 + 80 N#
Where, N = 1 - 5 (Representing the Extension numbers from 601 to 605)
To make the first Door Phone extension as a normal Extension, program as below:
Dial #0000 + 800 #
Door Phone ring assignment
Dial #0000 + 82 N # - To assign extensions to ring when Door Phone calls.
Where, N= 1 – 5 (Representing the Extension numbers from 601 to 605)
Repeat the program for up to 3 Extensions maximum except door phone.
Dial #0000 + 82 # - To clear all programmed extensions for Door Phone calls.
.
When any extension dials # 88, all extensions start ringing. All extensions get connected to the extension who had dialed
the Emergency code. All can talk in conference.
. Conference with 1 Junction & 1 Ext .