Call Forward When Busy / No Answer (This can also be used as Round Robin feature - Refer “Junction Line Ring
Assignment”)
If calls are to be diverted only when the Extension is busy or is not answering, then:
Dial # 27 N XXXX
Where, XXXX= Extension number where Calls are to be forwarded. If flexible numbering is done then
enter the Flexible number. If the Flexible number is say 26 then XXXX will be = 26 &
not 026.
N= The last digit of the original Extension number (Not the flexible number)
Dial # 27 N # (To clear the feature of NN Extension
: To cancel Call Forwarding Busy / No Answer of all the extensions:
Dial # 27 # from any of the programming Extensions.
: To cancel all type of Call Forwarding of all the extensions:
Dial # 25 # from any of the programming Extensions.
: To retain the Call Forwarding programming after the PBX is switched ON/OFF,
Dial #0000 + 171 # (This is the default setting in the PBX)
: To lose the Call Forwarding programming after the PBX is switched ON/OFF,
Dial #0000 + 170 #
Ring Time change in Call Forward When Busy / No Answer
The ring time on extension, in case of Call Forward, can be changed using the following program:
Dial #0000 + 184 TT #
Where, TT= 01 – 99 Ring Time in seconds
Default value = 20 secs
Note: The time entered here, should be less than the Internal Call Ringing Time.
PBX has a code for call pick up as detailed below:
Dial # 9 - To pick up an incoming Junction call ringing on another extension.
It will pick the calls in following priority
Junction Call being Transferred
Incoming Junction Call ringing
Junction Call on Hold
Door Phone Call
Internal Call
The incoming Junction call telephone number is displayed on the LCD of the CLI phone on which the defined Junction call
rings. This feature will work with Telephones having CLI feature.
When a Junction call is transferred from an extension to another extension, the external telephone number is displayed on
the LCD of the CLI phone. When an extension calls another extension, Extension number is displayed on the LCD of the
CLI phone.
Some CLI Telephones cannot display less than 4 digit numbers. In that case if the PBX extension numbers are less than 4
digits then additional dummy Zeros need to be added by the PBX.
Procedure:
To Enable, Dial #0000 + 180 1 #
To Disable, Dial #0000 + 180 0 #
Note- If CLI digit addition is enable then if extension is of 2 digits then 2 dummy zeros are added before extension number
and if the extension number is of 3 digits then a zero is added before the extension number.
Default: Disabled
The system senses CLI on Junction lines in DTMF mode or FSK mode.
Procedure:
Dial #*0000 +1810# for FSK mode
Dial #*0000 + 1811# for DTMF mode
Default: FSK mode
.
The PBX generates CLI on Extensions in DTMF mode in default.
To Next Page
Loading...
