The two versions are not exchangeable!
The VX 820 ITS PIN pad is recognised by the green sticker with the text ITS. This sticker is applied on the
packaging of the product and the bottom of the PIN pad.
2.2 Installation provisions
To install the VX 820 ITS PIN pad, the following provisions must be available at the location of the installation:
• A network connection at 1.5 metres from the PIN pad, at the most, via which the PIN pad can be connected to the
network that also comprises the cash register;
• A wall socket with 220-230V at 1.5 metres from the PIN pad, at the most (preferably a group that does not contain
major users).
To install the PIN pad and provide services on it, you make use of the program AdminLight. The conditions below must
be met in order to use this program:
• AdminLight must have been installed on a PC within the LAN network to which the VX 820 ITS PIN pad and the cash
register are also connected;
• depending on the settings of the LAN network where you are going to install AdminLight, you may need to possess
administrator rights to be able to install the program;
• Java (TM) Platform SE Binary (version 6.0.180 or higher) must have been installed on the PC where you want to use
AdminLight;
• any firewall in the network must have been configured in such a way as to enable communication between
AdminLight and the VX 820 ITS PIN pad. Also, the PIN pad must be able to communicate with the outside world.
2.3 Positioning instructions
The Dutch payment association Betaalvereniging Nederland has a number of objectives, including the security of
electronic payment transactions. To increase this security, Betaalvereniging Nederland has drawn up guidelines for
positioning of the point-of-sale terminal and the use of the card reader.
2.3.1 Positioning the PIN pad
Observe the following instructions when positioning the PIN pad:
• Place the PIN pad in such a way that the card holder is able to screen off the entering of the PIN code with his hand or
body. Therefore, when placing the PIN pad horizontally, the following measurements must be observed:
o place at a height of minimum 80 cm and maximum 120 cm. This may only be deviated from if the entering of the
PIN code is fully screened off by a special setup.
• The entering of the PIN code may not be visible from an elevation, via mirrors, via cameras, or in any other way.
• The keypad of the PIN pad must be set up in such a way that the card holder has sufficient privacy while entering the
PIN code during the transaction. This makes it impossible (within reason) for third parties to view the PIN code.
• The PIN pad is provided with a privacy shield. This shield around the keypad can be used by the card holder to screen
off the entering of the PIN code. If your PIN pad does not have a privacy shield, please contact our Product Support
Desk via +31 (0)88 228 9783.
CID087A/15042015 © CCV Services B.V. 8 / 45
To Next Page
Loading...
