12
•
How to set the time
--
When supplied with electricity
The display flashes 12:00. (fig.1)
Set the time by pressing the + and - touch
controls (pressing and holding the touch
control makes the numbers advance more
quickly) (fig.2).
Example: 12:30
Press the “ ” touch control to enter.
The display stops flashing.
- To reset the clock time
The function selector must be in the 0 posi-
tion (fig.1).
Press and hold the “ ” touch control for a
few seconds until the display is flashing
(fig.2), then release. Beeps are sounded to
indicate that it is now possible to set.
Adjust the clock setting with the + and - touch
controls (fig.3).
Press the “ ” touch control to confirm
(fig.4).
fig.1
fig.2
fig.2
Warning
If the “ ” touch control is not
pressed, the setting will
be automatically recorded after a few sec-
onds.
fig.3
fig.4
To Next Page
Loading...
