CDA wc431 User Manual

7
Half-Load B ut t on (4) and Indicator L ight
The dishwasher is equipped with a half-load function that allows
for small numbers of dishes to be washed, spread between both
baskets. This reduces the amount of water and electricity used.
• To use this function, press the half-load button (4), the
indicator light shows to indicate that this function is
selected.
If you have selected the half-load function for a programme,
this function will automatically be selected the next time the
dishwasher is used. To cancel the selection of this function,
press the specific half load button (4) until the indicator light
goes out.
Delay Timer Button (5)
The dishwasher is equipped with a variable timer of 3, 6 or 9
hours to delay the start of a programme.
• To set the delay timer, press the delay timer button (5). This
will switch the timer on for 3 hours.
• Pressing the delay timer button (5) again will increase the
delay to 6 hours, a third press increases the time to 9
hours. The delay time selected will show on the indicator
lights (6).
• To cancel the delay timer, press the delay timer button
again until none of the indicator lights (6) are lit.
Salt, Rinse Aid Warning Lights and End of Programme Light (7)
When the dishwasher salt or rinse aid begins to run out, the
warning light will illuminate to advise that it needs refilling.
When the programme is complete, the dishwasher will emit five
beeps and the end of programme indicator light will illuminate.

CDA wc431 Specifications

General

Door color	Not applicable
Built-in display	No
Appliance placement	Fully built-in
Control panel color	Black, Stainless steel
Noise level	52 dB
Delay start (max)	9 h
Delayed start timer	Yes
Dishwashing programs	Eco, Intensive, Pre-wash, Quick
Number of place settings	10 place settings
Number of washing programs	6
Drying class	A
Annual energy consumption	237 kWh
Water consumption per cycle	13 L
Energy consumption per cycle	0.83 kWh

Weight and Dimensions

Depth	570 mm
Width	448 mm
Height	870 mm