8
Starting a Programme
• Press the Power button (the end of programme light will be
switched on)
• Press the Programme Selection button until the required
programme is shown on the display.
• If required, set the delay timer by pressing the Delay Timer
button
• Once a programme is selected, the end of programme light
will switch off.
• When you close the dishwasher door, the programme will
start automatically.
Please note: The dishwasher stores the most recently used
programme in its memory. To change the programme,
simply press the Programme Selection button.
At the End of a Programme
If possible, do not open the dishwasher door once the programme
has started.
At the end of a programme, the dishwasher will beep five times,
and the end of Programme Indicator light will switch on.
Changing a Programme
It is possible to change the programme if necessary once the
programme has started.
• First open the door slightly to reduce the risk of water
spillage.
• Press the programme selection button until the required
programme is shown on the display.
• Then close the door. The dishwasher will begin the new
programme from the point at which the old programme
stopped.
To Next Page
Loading...
