CDVI CT-V900 - Controlled Entry with Free Exit; Turnstiles

CT-V900 CONTROLLER 21
CT-V900 CONTROLLER SPECIFICATIONS
Entry through two doors can be controlled with one controller by installing a reader/keypad on one side of each
door. If the door status is monitored by a door contact (reed switch) then a “request to exit” (REX) device such as a
 motiondetector,pushbuttonoroormatsensormustbeusedsothatthesystemcandifferentiatebetweenadoor
 forcedopenandanauthorizedexit.TheREXcanbeprogrammedforfreeexitaccordingtoaspecicschedule,
otherwise a “door forced open” event will be generated.
TURNSTILES
Most types of turnstile equipment on the market are controlled by an unlock control input which is connected to a
solenoid. The installation may require additional relays or the use of a CA-A110 Lock Control Module.
Figure 16: Controlled Entry With Free Exit
Figure 17: Turnstile Conguration
www.cdvgroup.com