CDVI CT-V900 - System Overview; Power Requirements

SYSTEM OVERVIEW
SYSTEM REQUIREMENTS
POWER REQUIREMENTS
• Transformer: 24VAC, 75VA
• Backup Battery: Two 12VDC, 7Ah, gel type batteries
OPERATOR COMPUTER REQUIREMENTS FOR CENTAUR 2.0 AND 3.0
• Pentium 133MHz (Pentium 200MHz or higher recommended)
• Microsoft® Windows® 95/98 or Windows® NT service pack 4.0 or higher
• 32MB RAM (64MB Recommended)
• 200MB free disk space (300 Recommended)
• RS-232 Serial Port
• CD-ROM Drive required for installation
• Super VGA Monitor
ACCESS SERVER COMPUTER REQUIREMENTS FOR CENTAUR 3.0
• Pentium 200MHz (Pentium 300MHz or higher recommended)
• Microsoft® Windows® NT service pack 4.0 or higher
• 64MB RAM (128MB RAM Recommended)
• 300MB free disk space (1GB Recommended)
• RS-232 Serial Port (Depending on the installation, more than one may be required)
• CD-ROM Drive required for installation
• Super VGA Monitor
COMPATIBLE READERS AND KEYPADS
• CR-R880 Series PosiProx Proximity Reader.
• CK-POSK-0 BCD and Wiegand Keypad, CK-K616 / CK-K626 Wiegand Keypads
• Keypads which conform to BCD, Motorola ARK or Wiegand outputs
• Supports bar code, magnetic and proximity readers which conform to the Wiegand standard 26/37 bit output, or
Track 2 magnetic card readers with cards that conform to the Position Technology Track 2 or ABA Track 2 format
• For an up-to-date list of which keypads and readers are supported, refer to the Centaur 3.0 Software Manual or
visit our web site at www.postech.ca.
ACCESSORY MODULES
POSIPROX CARD READER (CR-R880)
Proximity technology will never be the same again. PosiProx sets exacting new standards in design,
reliability, and affordability. With no equal in durability and a read range of up to 4”, the PosiProx and
proximity card and tag readers are the undeniable choice for access control applications.
POSIKEY KEYPAD (CK-POSK-0)
The rugged CK-POSK-O keypad will stand up to anything nature can throw at it. Designed to operate in an
indoor or outdoor environment and housed in a plastic or stainless steel package, this keypad still offers
rugged good looks and a host of programmable options to compliment your installation. Offering a complete
range of formats for interconnection into all systems with 26-Bit Wiegand, 37-Bit Wiegand, 8-Bit Wiegand
(emulates the ARK-501 Format) and BCD output as standard options.
RS-485 CONVERTER MODULE (CA-A360)
The CA-A360 RS485 Converter module is a communication interface that is installed between the managing
 computerandtherstcontrollerofyouraccesscontrolsystem.Twoconverterscanalsobeusedasa
repeater, extending the distance of an RS-232 or RS485 bus by 1220m/4000ft. Transmit, receive and power
LEDs provide visual indication of the module’s status.
NETWORK HUB (CA-A370)
 TheCA-A370NetworkHuballowsyoutowireanRS-485networkinastarcongurationalonganewor
existing RS-485 network without affecting the performance of the main network or devices connected to it.
4 INSTALLATION MANUAL www.cdvgroup.com