CDVI CT-V900 - Relay Expansion Module (Ca-A460); Elevator Floor Controller (Ca-A480); Lock Control Module (Ca-A110); Tracker Lcd Keypad (Ck-TRAK-L)

Using the CA-A370 provides higher network isolation from noise, thus greatly increasing communications
  reliability.TheCA-A370simpliesinstallation,andmakesrunninganRS-485networkmorecost-effective
by reducing wiring and installation time.
RELAY EXPANSION MODULE (CA-A460)
The Model CA-A460 Relay Expansion module provides an additional seven relays to a CT-V900 controller.
Up to 2 Plug and Play relay expansion modules can be added to each controller for a total of 16 relays per
controller. The relay expansion modules are connected to the controller via an RS-485 E-bus, allowing you to
install the relay modules a maximum distance of 1220m/4000ft. from the controller. The module features an
activation status LED for each relay, a communication failure LED with an associated output, a 24-hour
tamper input and supply monitoring. Removable terminals are optional.
ELEVATOR FLOOR CONTROLLER (CA-A480)
  Connectedtothecontroller’sexpansionbus,theCA-A480cancontrolupto16oors.EachoftheCA-A480
  oor control relays can be interfaced directly with an elevator’s oor control buttons in 2 modes (Non
Destination Controlled and Destination Controlled). When using the Non Destination Controlled Mode and a
  validcardispresented,theappropriateoorcontrolrelayswillbecomeenabledallowingthecardholderto
  selectthedesiredoor.TheDestinationControlledModeoffersafarsuperioreventtrailanduseraccountability
  bypermittingthecardholdertomakeonlyoneoorselectionuponpresentationoftheircard.Inthismodean
  eventisloggedindicatingtheselectedoor.Inadditiontotheseadvancedoorandelevatorcontrolfeatures,
  theCA-A480alsofeaturesfullsupervision,backupbatteryandarealarminput.
LOCK CONTROL MODULE (CA-A110)
The CA-A110 Lock Control Module has been designed to greatly reduce installation time and simplify the
connection of electromagnetic locks when used alone or in conjunction with door strikes. The CA-A110
  LockControlModuleconsistsoftwoon-board,heavyduty12Vrelays,twoinputsforrealarmcontacts
and two relay activation LED indicators. The relays, which are used to control power to the electromagnetic
  locks,aretoggledby the activation ofthecontroller’slock output terminalsorthe CA-A110’sre alarm
contact inputs.
TRACKER LCD KEYPAD (CK-TRAK-L)
The Tracker LCD Keypad serves as a display unit for your Tracker Time and Attendance Software. The
keypad’s buttons do not perform any actions. When an access card is presented to a reader assigned to
  Tracker,thekeypadwilldisplaythecardnumberaswellasaconrmationofavalidpunchinorpunchout.
When used with Anti-passback applications, the keypad will also display an error if the card user has already
punched in or out.
CT-V900 CONTROLLER
5www.cdvgroup.com